The device is the high voltage H-bridge, single chip LRA haptic driver, with LRA resonant frequency detect and tracking, with an integrated boost converter and integrated waveform memory, supporting real time playback and hardware pin trigger playback. Maximum drive voltage is up to 10.5V and a typical startup time of 1.2ms makes the device an ideal haptic driver for fast responses.

The device supports software controlled LRA resonant frequency(F0)detect, it can detect the actual F0 after LRA delivered to customer or the actual F0 after LRA mounted in the mobile.

The device supports LRA resonant frequency tracking based on LRA BEMF. It supports automatically tracks and generates the LRA resonant frequency.

The device supports LRA fault diagnostic based on resistance measurement.

The device supports real time playback for long waveform play. Software trigger and hardware trigger are supported for different applications.

The device integrates a high-efficiency boost converter as the H-Bridge driver supply rail. The output voltage, maximum current limit and maximum boost current are configurable.

The device features configurable automatically switch to standby mode. This can less quiescent power consumption. Dedicated interrupt output pin can detect real time FIFO status and the error status of the chip.

The device offers short circuit protection, over-temperature protection, under-voltage protection to protect the device.

The device features general settings are communicated via an I2C-bus interface and its I2Caddress is configurable.

The device is available in a FCQFN3mm x 2mm x 0.55mm-20Lpackage.


1MHz I2C Bus Control(Address: 0x5A/0x5B) 

LRA Resonant Frequency Detect and Tracking Option

LRA Fault Diagnostics based on Resistance

Drive Compensation Over Battery Discharge

Integrated 8-KByte Internal Waveform Memory

Up to 4-KByte Configurable FIFO Interface

Flexible Playback Modes:

Real Time Playback, Memory Playback, Hardware Trigger Playback and CONT Playback

1.2ms Fast Start Up Time

Support ≥8Ω LRA

Up to 3 Hardware Pins Trigger Input

Dedicated Interrupt Output Pin

High Voltage H-Bridge Driver

Integrated Boost Output Voltage up to 10.5V

Support Automatically Switch to Standby Mode

Standby Current: 8μA 

Shutdown Current: 0.2μA 

3Vto 5.5V Supply Voltage Range

Short-Circuit Protection, Over-Temperature Protection, Under-Voltage Protection

FCQFN3mm x2mm x0.55mm-20LPackage

AW8697A included Immersion IP license

AW8697B included Immersion IP and dedicated software license


Application note

Product name Type Size Download
  • Haptic Actuator Type
    Input Signal
    Max Output Voltage(V)
    SRAM (kB)
    LRA Calibration
    Startup Time (ms)
    Package (mm)
  • AW8697(A/B)*FCR

    I2C 3TRIG
    8(Compression \Demopression)
    FCQFN 2X3-20L
Package form Number of pins Long(mm) Width(mm) Thick(mm) Pin spacing(mm) Heat sink Package drawing
Privacy policy | Terms of use

© Copyright 2008-2020 Shanghai Awinic Technology Co., Ltd. |   沪ICP备10011954号  Powered by Yongsy