返回

AW32257FCR

AW32257 is a high efficiency, large currentswitch- mode Li-Ion battery charge management chip. The chip integrates 1.5 MHz synchronous Buck PWM controller, Boost PWM controller and power MOSFETs, effectively reducing the power loss.

The charge process of AW32257 includes: trickle, constant current (CC) and constant voltage (CV). The charge parameters and operating modes are programmable through I2C Interface. Also, the charge termination is determined by a programmable algorithm. The charge process runs automatically and recharging occurs when the battery voltage drops below VOREG-VRCH.

If the input source is removed, the IC enters a high-impedance mode, keeping ultra-low power loss from battery and preventing leakage from the battery to the input. Charge current is reduced when the die temperature reaches 140°C, protecting the device and PCB from damage.

The IC can operate in boost mode to support USB OTG device on command from system. The boost regulator uses same external components with charge mode, and it supports up to 1A output current for OTG device. Meanwhile, the output voltage of boost regulator can be configured from 5.05V to 5.35V by the host.


产品特性

l    High-Accuracy Voltageand CurrentRegulation

    - Charge Voltage Regulation Accuracy: ±0.5%(25°C), ±1%(0°C to 85°C)

    - Charge Current Accuracy: ±5%

l    Programmable Charge Parameters through I2CTM compatible Interface(100kHz/400kHz):

     -VIN DPM Threshold

    -Fast-Charge Current

    -Charge Regulation Voltage(3.5V to 4.5V)

    -Smart Charge Termination Algorithm

l    2.5A Charge Current using 33 mΩ Sensing Resistor

l    Specific K-DPMTM: VBUS Based Dynamic Power Management

l    Up to 94% Charge Efficiency

l    Trickle-CC-CV Three-stage Automatic Charging Process, Automatic Recharge

l    Bad Adaptor Detection and Battery Removing Detection

l    Strong Robust Protection: VBUS OVP, Minimum VBUS during Charging, Battery OVP, Reverse Leakage Protection, Thermal Shutdown

l    Charge Status and Fault Indication

l    5.05V,1A Boost Mode Operation for USB OTG for 3.5V to 4.5V Battery Input

l    FCQFN 2.0mm×2.0mm×0.55mm-20L Package

l    I2C Address=0x6A


Datasheet

Application note

产品型号 文档格式 大小 下载
  • Control Interface
    Operation Mode
    Max Charge Current (A)
    VOREG
    OTG
    Package (mm)
  • AW32257FCR

    I2C
    Host Control
    2.5
    Programmable
    FCQFN 2×2-20L
封装形式 引脚数 长(mm) 宽(mm) 厚(mm) 引脚间距(mm) 散热盘 文档下载
隐私政策 | 使用条款

© Copyright 2008-2022 上海艾为电子技术股份有限公司 |   沪ICP备10011954号  Powered by IT